ETW
EN
22
www.eberg.eu
SELECTION OF THE INSTALLATION SPOT
1. In order to avoid any danger to a very young
children, it is recommended that the lowest
heating bar should be located at least 60 cm
above the floor.
2. The device must be installed in such way that
the control panel of the device cannot be
accessed by a person in the bathtub or shower.
3. Keep a distance of at least 60 cm from other
devices, 20 cm from the ceiling, and 25 cm from
other walls.
4. The appliance should be installed in a dry place,
not exposed to direct contact with water, for
example on walls in front of or behind a toilet
or behind a door.
DANGER!
Danger of electric shock!
Product is suitable for operation only in „ZONE 3”.
DANGER!
Danger of electric shock! Before drilling the holes, make sure that there are no
electrical or other lines in the wall.
DANGER!
Risk of injury! The device may not be mounted directly below a wall outlet.
Danger of cable fires!
WARNING!
Property damage! When drilling, ensure that sufficient space is left between
the hole and the water lines located in the vicinity. There is risk of water damage.
PRODUCT INSTALLATION
1. Place the brackets with screws in the four holes of the device. Please note that the built-in slider
allows you to adjust the height of the brackets. The maximum distance between the upper and
lower brackets is equal to the total length of the device. Make sure that horizontally brackets on
the right and left are located at the same height.
