background image

IMPORTANT SAFETY ADVICE

The following safety advice must be always followed before using electrical equipment:

Please read carefully through the following information concerning safety and proper use. Before reading, fold out 
the page with the illustrations and make yourself familiar with all the functions of the equipment. Be careful to keep 
these advice notes and if necessary pass them on to a third party.

Do not operate the equipment if the mains plug, cable or the equipment itself is damaged.

If the equipment is dropped, then it must be checked by an electrician before further use.

Dangerous voltages are present inside the equipment. Never open the housing or insert objects through the ventilation holes.

Do not allow liquids to get into the equipment. In case of emergency, pull out the plug from the socket.

Similarly, if a fault develops during use or before you start to clean the equipment, pull the plug out if the socket.

Do not carry out any modifications or repairs to the equipment yourself. This includes changing the mains cable. Have repairs 
done to the equipment or the mains cable only by an electrician or at a specialist service centre. Unsatisfactory repairs can lead
to considerable danger for the user.

Children frequently underestimate the dangers associated with electrical equipment. Therefore you must never leave children 
unsupervised in the vicinity of electrical equipment.

In addition, you should never leave the equipment working unattended.

The equipment is not to be used in a damp room (e.g. bathrooms) or rooms where there is a lot of dust.

The heat building up inside the equipment can lead to faults or to it catching fire.

Do subject this equipment to extremes of temperature:
– Avoid direct sunlight and heaters
– Do not cover the ventilation slots
– Leave approx. 10 cm free around the sides

The equipment is not to be used in the direct vicinity of inflammable materials (e.g. curtains, inflammable liquids etc.).

If the equipment is brought into a warm room from the cold (for example after transport) then this can lead to condensation forming 
on the insides. To protect the equipment from damage, allow at least 2 hours before switching it on.

Equipment connected to the mains during a thunderstorm can be damaged by lightning. Therefore you should pull the plug out 
of the mains socket during a storm and disconnect the aerial.

To completely disconnect the equipment from the electricity supply, the plug must be removed from the socket. When doing this 
always pull on the plug itself and never on the cable.

Protect the mains cable from hot surfaces or other sources of damage and do not allow it to become constrained.

Check the mains cable regularly for any damage.

Unwind the mains cable completely before use.

Make sure that the mains cable does not represent a trip hazard.

If you are likely leave the equipment unattended for a long period, pull the plug out of the socket and take out the batteries 
from the remote control.

The equipment is intended for private and domestic use only.

Note:

The Designer Audio Unit is provided with anti-slip rubber feet. The rubber feet may become stuck to or softened by the material 

used for or used to clean the supporting surface. This cannot be excluded because of the variety of materials in common use. 
You should therefore place an anti-slip layer under the feet.

Environmental protection:

Never use combinations of new and used batteries. Never dispose of used batteries in the household 

waste. Take them to an appropriate collection centre.

SETTING UP AND CONNECTING THE EQUIPMENT

You must follow the instructions given when preparing to use the equipment for the first time and only then insert the plug into 
the socket.

1)  Carefully take the Designer Audio Unit and the loudspeakers out of the packaging.
2)  Choose a suitable position for your Designer Audio Unit. It should be

... horizontal
... dust-free and dry
... away from heaters and direct sunlight.

3)  IMPORTANT: Remove all transport restraints /adhesive tape from the CD and cassette drive compartments !.

Open the CD compartment 

!

by pulling the top edge and removing the red transport restraint (then closing the CD compartment 

again).

4

Содержание KH 2330











Отзывы: