General Installation Guide
Use Key to disassemble
Bottom Case & Middle Case.
Mount the Bottom Case on the wall and
connect the wires to the PCB output terminal.
Surface Mount Instruction
1
2
Buckle in the middle case to the bottom
case clipping as shown in the diagram
below.
Insert the Key to reset the status indicator back to
Green. Then pull out the Key.
1
1.
2.
3.
4.
Embedded Mount Instruction
1.
Bottom case is not use
in embedded installation.
Use Key to disassemble Top case & Middle Case.
** See Important Notice.
Buckle Clip
Cut off the unused buckle clip
portion if its blocking the
embedded surface mounting.
Lateral
View
2.
Complete
Case & Cover
3.
4.
Buckle Clip
Connect all the wires to the PCB
output point, then mount the middle
case onto the embedded box with
screw *.
Buckle up the clip between Top
case & Middle case as shown in
the diagram below.
2
5.
Pg.2/2
1
2
1
2
Use Key to disassemble Bottom Case & Middle Case.
Note:
* screw is not provided.
It vary depend on the
embedded box design.
screw *
Insert the Key to reset the status
indicator back to Green. Then pull
out the Key.
Copyright
EBELCO
Industries Sdn. Bhd. All Right Reserved.
EISB-EDR-IG Ver.A Publish:16.1.2020
