�
eBeam
®
ed
g
e
+
-
。
Use the 1 m USB charging
cable to charge your Edge+
Stylus with any USB
power adapter.
Once fully charged, your
stylus can be used
continuously for up to
15 hours.
。
*Note:
You also can place
the sensor directly onto
magnetic surfaces without
using the plate.
。
Connect your projector
to your computer.
0
Hold the sensor and
prepare to place it carefully
in the indicated location.
Allow a 5cm margin
between the sensor and
writing area.
\
`
。
。
Turn on your projector and
align/focus the image on
the projected surface.
Place the sensor so that it
is centered vertically on the
projected surface, parallel
to the projection edge.
Connect the micro USB
cable to your Edge+ Sensor.
。
Connect the Edge+ USB
cable to your computer's
USB port. Install and run the
eBeam software.
Download at:
https://www.
L
uidia.com/apps/
#
edgeplus
_
apps
Place a mounting plate
onto the back of the sensor
with the Command
adhesive side facing out.
*(See note for magnetic
mounting option)
。
Peel the Command adhesive
backing from the sensor.
휠
e
•....
i
. .
After the eBeam software 1s
launched, calibrate the system.
Cong『atulations!
Your eBeam Edge+ system is
now 『eady for use.