ebatec GS 21, Руководство по эксплуатации

Страница: 3 / 18

Assemble the bottle basket, after having correctly installed and connected the
machine
Refer to the instructions on page 12 to 16.
Then, adjust the rinsing nozzles.
Refer to the instructions on page 17 to 18.
First commissioning
with a few turns. Reinstall the Plexiglas cover on the dosing pump and reinstall the
panel on the machine.
Rinsing
Check if the suction filter is in the required position.
Page 3
Remove the panel below the door, by
unscrewing the 2 screws on the left
and right.
The screws are secured with a split pin.
ATTENTION: PULL THE MAINS PLUG!!
DO NOT REACH INSIDE THE MACHINE
The dosing pump is located behind the panel at the
left front.
Please check if the setting of the dosing is the same
as in the picture on the left.
Position the arrow to 1 o’clock.
Otherwise set with a small screwdriver as illustrated
If the machine is delivered in the cold season, the
axial wheel might get stuck on. In this case, remove
the Plexiglas cover and turn it manually
Attention: There is a risk of
chemical burns when using
chemicals. There always
wear safety goggles and
gloves.
Insert the overflow pipe into the
opening of the suction filter.
Put the surface filter into the
machine (first remove the protective
film).