16
EBA 721-05
05-02
4.2 Turning or replacing the cutting stick
- Turn the blade depth adjustment (27) to the top
until it stops (spanner in tool set).
- Remove spanner.
Danger! Risk of injury!
- Take out the cutting stick (26) with a small
screwdriver.
- Turn the cutting stick (the non-used side must be
near to the blade) and plug it into the holding bolt.
The cutting stick can be used eight times.
- Put a sheet of paper onto the whole width of the
cutting area.
- Lower the blade by pressing both cut buttons.
Keep one button pressed and turn main switch to
position "0".
- Lower the blade depth adjustment (27) until the
paper is cut along the entire length.
- Remove spanner.
- Turn main switch to position "I".
Cutting test
- Put a sheet of paper onto the whole width of the
cutting area.
- If the sheet of paper is not completey cut, lower
the blade adjustment (27) 1/12 using the spanner.
- Remove spanner.
- Repeat this procedure until the paper is cut along
the entire length.
