Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
44
Passive Point Source
Application Guide
Input Setup
Open the configuration Dashboard and select the
Input Tab
. The Input Tab is shown in
Diagram 4b.
• To edit default input names simply select and type
in the Input Name field.
• Define a mono or stereo input by selecting the
appropriate option. Defining a stereo input
will reduce the total number of discrete inputs
available.
• Select an input sensitivity option from the drop-
down menu: +14dB, +4dB, -10dB and ‘microphone’
options are available. Generally, the +14dB or +4dB
options are appropriate for ‘professional audio’
source hardware with balanced outputs, while the
-10dB option is more appropriate for ‘consumer
audio’ source hardware with unbalanced outputs.
The ‘microphone’ option provides the significantly
greater sensitivity required for microphones.
Note:: Only dynamic microphones are suitable for
connection. Phantom power for condenser microphones
is not provided.
• If necessary, adjust the input gain using the slider
or up/down icons. Gain adjustment is intended to
be used for fine output level adjustment following
initial use.
Zone Setup & Routing
Open the configuration Dashboard and select the
Zone Tab
. The Zone Tab is shown in
Diagram 4c.
• Select the zone to be configured. The number of
zones available and their channel format (stereo
or mono) will depend on the amplifier model,
input setup and output mode (Lo-Z or Hi-Z). For
example, a two output amplifier can have the
following zone configurations:
• 1 x stereo Lo-Z zone
• 2 x mono Lo-Z zones
• 1 x mono Hi-Z zone
• A four output amplifier can have the following
zones configured:
• 2 x stereo Lo-Z zones
• 4 x mono Lo-Z zones
• 2 x mono Hi-Z zone
• 1 x mono Hi-Z zone + 1 x stereo Lo-Z zone
• 1 x mono Hi-Z zone + 2 x mono Lo-Z zones
Note: When configured in Hi-Z mode UXA Amplifier
amplifiers operate in ‘bridged’ mode where the output of
two channels is combined. This means that the number
of output channels available in Hi-Z mode is half that
available in Lo-Z mode .
Note: Mono signals might be mono at source, created
though combining the left and right channels of a stereo
signal (summed mono) or treating the left and right
channels of a stereo signal independently (split mono).
• Name zones by typing in the Zone Name field.
• Adjust the zone volume if required by using the
slider.
• Define a mono or stereo zone by selecting the
appropriate option. Defining a stereo zone will
reduce the total number of further zones available.
• Specify an input for the zone by selecting from
the drop-down menu. Selecting a stereo input for
a mono zone will automatically sum the stereo
channels to mono.
