ASG Tech Note: Connecting and Communicating with DSA
Page 7 of 10
5C. Assign Your DSA Modules to Their Respective Clusters.
Once you have added the cluster you will be working on, you will need to assign
individual DSA modules to its respective cluster. This is done by left clicking the individual
DSA module so it grays out, clicking the ‘ASSIGN’ button (the button will light up, a stylus
will now appear where your cursor/arrow was), then left clicking on the respective DSA
module under the cluster you wish to assign that module to.
For example, if you were using a 1C cluster (single DSA230, LED at bottom), you would
left click on the DSA230 in the ‘Unassigned Module’ window so it grays out, click on the
‘ASSIGN’ button, then left click on the DSA230 shown under the Unnamed Cluster, which
is your 1C cluster.
When you assign a DSA module for the first time, from a new DSA Pilot window, you
should be able to connect immediately. However, if there is a mismatch – if the DSA
module has information in it – you will get a window prompt asking you what you want to
do:
