xComfort Room Controller Touch – Effect Regulation - User manual 2v00_EN
1 |
P a g e
1. Introduction
1.1 Safety instructions
This document contains important warnings and safety instructions which must be observed and
followed by users. Failure to follow these warnings and safety instructions may cause the Room
Controller Touch to malfunction.
1.2 Intended use
The Room Controller Touch has been designed solely for residential use in private homes and small
offices. It is not suitable for industrial use.
The Room Controller Touch is designed to facilitate room climate control via an intuitive LCD
touchscreen menu.
This document describes the operation of the Room Controller Touch if used in
Effect Regulation
mode.
Temperature-based control is described in a separate user manual.
The Room Controller should be set to Effect Regulation mode during installation. This
mode is activated if the temperature screen displays a percentage (%) instead of a
temperature value (°C). Contact your installer for more information.
In contrast with temperature regulation, which is based on the measured temperature, the Effect
Regulation mode uses a set percentage of time during which the heating should be active to control the
room climate. Effect regulation is typically used in situations where no reliable temperature
measurements are possible.
Since the transmission of radio signals is based on a non-exclusive communication
channel, interference is possible. As a result, the Room Controller Touch must not be
used to control components with safety-related functions, such as devices for protection
against overheating, emergency stop or emergency call.
The use of the device for any purpose other than that described in this document, and failure to observe
the warnings and safety instructions it contains, will immediately invalidate the warranty and/or any
liability claims.
1.3 Instructions for disposal
Do not dispose of this device with regular domestic waste.
Electronic equipment must be disposed of at local collection points for waste electronic
equipment and in compliance with the local regulations governing waste electrical and electronic
equipment.
1.4 About this document
These operating instructions are intended for end users and describe the operation and menu structure
of the Room Controller Touch with software version 1v36 or higher.
