7
5. Configure a router CROU-00/01 in Basic-Mode
1. If there is no RF connection between push button
and an actuator, an additional router can be
configured to extend range.
2. To assign a push button to a router:-
a) Press the router configuration pushbutton with a
screwdriver for less than 0.5 sec => router enters
teach-in mode, the LED in the router is on
b) Press the selected pushbutton for less than 0.5 s
c) LED in the router flashes 20x for confirmation
d) Press the router configuration pushbutton with a
screwdriver for less than 0.5 sec => router leaves
teach-in mode
3. Press the actuator configuration pushbutton with
a screwdriver for less than 0.5 sec => actuator
enters teach-in mode. Note the LED in the router
should be off i.e. not in (teach-in mode)
4. Press the Push button and the command is now sent to the router and from there forwarded to the actuator.The
LED in the actuator flashes twice for confirmation.
5. Finally press the configuration pushbutton with a screwdriver for less than 0.5 sec => actuator leaves teach-in
mode
6. Configure two routers CROU-00/01 in Basic-Mode
1. If the range of a single router is not sufficient, a
second one can be added to extend RF range
further
2. Assign a push button to first router as detailed in
section 5 above.
3. Assign second router to push button in the exact
same manner as the first.
4. Press the actuator configuration pushbutton with a
screwdriver for less than 0.5 sec => actuator enters
teach-in mode. Note the LED in the both routers
should be off i.e. not in (teach-in mode)
5. Press the push button and the command is sent to
the routers and from there forwarded to the
actuator. LED in the actuator flashes twice for
confirmation.
6. Finally press the configuration pushbutton with a
screwdriver for less than 0.5 sec => actuator leaves
teach-in mode
