Eaton Lighting Systems iLight Product Series - SCD24 IM7524 iss 4 7
Override Mode
Placing the unit into override mode
allows for testing of the Source
Controller outputs regardless of how
the unit is currently programmed. This is
useful for testing power to circuits prior
to the system being commissioned or
for fault finding where it can be used to
test if there is an issue with the Source
Controller output(s) should this be
suspected.
When the Source Controller is placed
into override mode it will no longer
respond to commands sent over the
iCAN network.
Override mode can also be used to
restore power to outputs if control is
lost or termporarly removed to allow
lighting to remain on until control is
restored.
NOTE: Override mode only affects the
outputs on the Source Controller on
which it is activated.
To exit diagnostic / override status
follow the steps shown. If power is
cycled to the Source Controller then this
will also take the unit out of override
mode and it will start up in the default
running status.
