16
When UPS is in battery mode, the number of the icons of the
charger-state section will vary according to the changeable capacity
of the battery (pane). For example, there are five panes in Fig.A,(as
the right picture of the Graphics(3) shows), so the corresponding
number of icons is five rows(as the left picture of the Graphics(3)
shows),, followed by this rule,
(3)
5.2 Operation
5.2.1 Start up operation
Turn on the UPS in line mode
①
Once mains power is plugged in, the UPS will charge the battery,
at the moment, LCD shows that the output voltage is 0, which means
UPS has no output. If it is expected to have output of bypass, you
can set the bps “ON” by LCD setting menu.
②
Press and hold the ON/OFF key for more than half a second to start
the UPS, then it will start the inverter.
③
Once started, the UPS will perform a self-test function, LED will
light and go out circularly and orderly. When self-test finishes,
it will come to line mode, the corresponding LED lights, UPS is
working in line mode.
Turn on the UPS by DC without mains power
①
When mains power is disconnected, press and hold the ON/OFF key for
more than half a second to start UPS.
②
The operation of UPS in the process of start is almost the same as
that when mains power is in. After finishing the self-test, the
corresponding LED lights and UPS is working in battery mode.
5.2.2 Turn off operation
Turn off the UPS in line mode
①
Press and hold the ON/OFF key for more than half a second to turn
off the UPS and inverter.
②
After UPS shutting down, LED go out and there is no output. If output
is needed, you can set bps “ON” by LCD setting menu.
Turn off the UPS by DC without mains power
①
Press and hold the ON/OFF key for more than half a second to turn
off the UPS.
②
When turning off the UPS, it will do self-testing firstly. LED light
and go out circularly and orderly until there is no display on the
panel.
