7
Instructional Leaflet
IL0131093EN
Effective January 2019
Instructions for secondary terminal blocks
EATON
www.eaton.com
Step 6:
Repeat Steps 4 and 5 until all terminal blocks are
mounted, and check to ensure they are positioned in the cor-
rect locations. A small number terminal blocks would look as
shown.
Figure 19. Step 6.
Step 7:
Carefully put the terminal block alignment bracket
back into position by sliding it back into the mounted terminal
blocks.
Figure 20. Step 7.
Step 8:
Push the terminal block alignment bracket over
the posts located on the terminal block mounting bracket.
Ensure the alignment bracket is fully seated.
Figure 21. Step 8.
Step 9:
Once the terminal block alignment bracket is in place,
inspect it from the bottom to ensure that the teeth on the
bracket separate each individual terminal block. Only one
installed terminal block only should be visible between two
teeth when the alignment bracket is properly positioned.
Figure 22. Step 9.
Step 10:
To remove already mounted terminal blocks, first
remove the terminal block alignment bracket by performing
Steps 2 and 3 in this section.
Step 11:
Remove any terminal block by inserting a small
screwdriver under the mounting plate retainment tab at the
top front of the terminal block as shown, and gently pry
down to release and remove the block from the mounting
bracket.
Step 11.
Step 12:
After all terminal blocks to be removed are
removed, perform Steps 7, 8, and 9 in this section to com-
plete the removal process.
