Eaton PDI WaveStar BCMS, Инструкция по установке и эксплуатации

Страница: 9 / 54

Eaton PDI WaveStar BCMS Hub Installation and Operation Manual P-164001108—Rev 01 1
C Chhaapptteerr 11 S Saaffeettyy
Please pay special attention to the use of “Danger” symbols throughout this manual indicating electrical or
other safety hazards. Following these safety instructions is extremely important to avoid possible injury or
death.
This symbol is used throughout this manual to indicate the presence of high voltages, representing a hazard for
electric shock, burn or explosion. Follow the instructions carefully to avoid serious or fatal injury.
Follow safe electrical work practices:
• Disconnect and lock-out all power supplying equipment before working on or installing WaveStar® BCMS
Hub components. Use a properly rated voltage sensing device to confirm power is OFF.
• Electrical equipment should be installed, operated, serviced, and maintained only by qualified personnel
and in accordance with all local safety codes. Eaton assumes no responsibility for any consequences
arising out of the use of this manual. This document should not be viewed as sufficient by otherwise non-
qualified personnel to operate, service, or maintain the equipment discussed.
• Read, understand, and follow the instructions before installing this product.
• Install device in an appropriate electrical enclosure per local regulations.
• ESD sensitive equipment. Ground yourself, discharge any static charge and ensure that the device is
effectively grounded before handling the unit.