Eaton PDI WaveStar BCMS, Инструкция по установке и эксплуатации, Страница: 32 / 54

24 Eaton PDI WaveStar BCMS Hub Installation and Operation Manual P-164001108—Rev 01
• If Offset = X, the Modbus addresses of downstream devices as seen from the Hub are shown.
• If Offset = √, the Modbus address of the BCMS Hub is added to downstream device addresses for display.
These are Modbus addresses as seen from the upstream client device, such as a BMS or DCIM system.
Figure 17. Modbus Settings: Modbus Address Offset
44..22..22 EEtthheerrnneett S Seettttiinnggss
IMPORTANT ! After changing any Ethernet settings, you must restart the BCMS Hub. Touch Restart in
Ethernet Settings ( Figure 16 ) and wait for the system to reinitialize itself.
The Monitor backpanel has an Ethernet port. A customer-supplied Ethernet cable must be physically attached
to the customer network and an Ethernet IP address must be set before Modbus TCP/IP or SNTP Time
Synchronization is configured.
The Ethernet Settings panel in the Settings screen ( Figure 16 ) allows the operator to set an IP address if a
different address than the DHCP address is required.
• Toggle Use DHCP button:
• Green check mark(√) : Use DHCP to assign IP address
• Red X: Do not use DHCP; provide IP value in Address .
• Address is the Ethernet IP address of the Switch, which can be set directly or by DHCP.
System Setup