DRAFT - 11 December 2014
DRAFT - 11 December 2014
16
DRAFT - 11 December 2014
INM MTL4850_54 Rev4
4.7 Backplane mounting
4.7.1
Surface mounting
4.7.2
Surface mounting kit (type SMS01) is available for this purpose. SMS01 contains 40
sets of the components shown in Figure 4.12.
Prepare panel
a) Refer to Figure 4.10 or 4.11 for mounting hole positions.
b) Prepare holes in the mounting surface at the centres shown. Thread these (M4) if
retaining nuts will not be used.
Fit backplane
Refer to figure 4.12.
a) Select an M4 x 20mm screw (A).
b) Place a locking washer (B) and a plain washer (C) over it.
c) Insert the screw through a fixing hole on the baseplate.
d) Fit a 10mm spacer (D) and retain it with washer (E).
e) Repeat steps a) to d) for the other five (5) mounting holes.
f) Attach the baseplate using the prepared panel holes. Retain the screws with a suitable
nut if the holes are not tapped.
4.7.3
DIN-rail mounting – with DIN-rail mounting kit DMK01
DIN-rail mounting kits (type DMK01 or DMK04) are available for this purpose. DMK01 contains 40
sets of the components shown in Figure 4.13, while DMK04 contains 4 sets of these components.
Figure 4.12
Surface mounting
kit
components and
assembly details
Figure 4.13
DIN-rail mounting
kit
components and
assembly details
