Eaton Moeller SmartWire-Darwin Series, Аппаратное обеспечение и инженерия

Страница: 61 / 132

Exchange of Modules
57
06/09 AWB2723-1613en
Exchange of Modules
After replacement of the modules and connection of the
voltage the configuration button must be pressed. The new
module is assigned an address by this means.
Motor starter or contactor
Device status The individual SmartWire-Darwin slaves indicate their device
status with the aid of a diagnosis LED.
Table 5: Diagnostic messages of the SmartWire-Darwin module
for DILM (LED indicator)
j
Danger!
The exchange of the SmartWire-Darwin module for DILM
must only be carried out with the supply switched off.
h
Caution!
The order of the SmartWire-Darwin units must not be
altered.
i
Danger!
The exchange of the motor starter or contactor must only
be carried out after the complete system SmartWire-
Darwin is switched off.
Designation Colour State Message
Ready Orange Continuous light Switching command for contactor via
SmartWire-Darwin
Green Continuous light Device is operating fault-free.
Flashing (1 Hz) • addressing process in progress
– after gateway power On
– after actuation of the
configuration button on the
gateway
• slave not in current configuration
• invalid type