![background image](http://html1.mh-extra.com/html/eaton/moeller-mfd-cp4-co/moeller-mfd-cp4-co_hardware-and-engineering_4111690015.webp)
11
05/08 AWB2528-1611en
2
Installation
The MFD-CP4-CO must only be installed and connected up
by trained electricians or a person familiar with the installa-
tion of electrical equipment. The MFD-CP4-CO is installed in
the following order:
• Mounting,
• Connecting the serial interface,
• Connecting the power supply.
Mounting
Install the display/operator unit in the front of a control
cabinet, a service distribution board, operator panel or in an
enclosure. You can protect the display/operator unit with a
protective membrane or cover, depending on the environ-
ment in which it is to be used. This must be fitted before the
MFD-CP4-CO is mounted and is therefore described in the
next section.
The MFD-CP4-CO communication module must be mounted
in such a way that all the terminals are protected against
direct contact, liquids and dust during operation.
For sufficient heat circulation around the device, the rear of
the MFD-CP4-CO and the terminals must have a clearance of
at least 3 cm from the wall or adjacent devices.
Figure 6: Minimum clearance for mounting
30
30
30
Содержание Moeller MFD-CP4-CO
Страница 1: ...Display Operator System for CANopen MFD CP4 CO MFD 80 Hardware and Engineering 05 08 AWB2528 1611en ...
Страница 14: ...10 05 08 AWB2528 1611en ...
Страница 23: ...Mounting 19 05 08 AWB2528 1611en Mount communication module Figure 17 Mount communication module ...
Страница 38: ...34 05 08 AWB2528 1611en ...