Eaton Micro Panel XV-102, Руководство по эксплуатации

Страница: 37 / 70

5 Installation
5.3 Interfaces
MICRO PANEL XV-152
12/2011 MN04802006Z-EN www.eaton.com
37
Configuration check
Each time the supply voltage is switched on, the configuration checks are performed:
1 The slaves actually found on the network are compared with the target configuration stored in the
device.

If the physical structure of the SmartWire-DT network matches the target configuration, the
SmartWire-DT network is ready for data exchange.
2 The target configuration stored in the device is compared with the project configuration defined in
the PLC.

If the target configuration matches the project configuration, the Config LED lights up.
Tab. 16 SWD LED and Config LED
LED State Meaning
SWD Off No target configuration.
Red continuous light

Short-circuit on the 15 VDC power supply.

No SmartWire-DT slave found.
Red flashing

The slaves found in the SmartWire-DT netwerk do not match the tar-
get configuration.

A SmartWire-DT slave configured as necessary is missing.
Orange flashing The physical structure of the SmartWire-DT network is read and stored
as the target configuration.
Green flashing

The physical structure of the SmartWire-DT network is compared
with the target configuration.

The SmartWire-DT slaves are addressed.
Green continuous
light The slaves found in the SmartWire-DT netwerk match the target config-
uration. The SmartWire-DT netwerk is ready for data exchange.
Config Off

No project configuration.

Faulty target configuration (see SWD LED).
Red continuous light Project configuration and stored target configuration are not compat-
ible.
Green flashing Project configuration and stored target configuration are compatible.
Green continuous
light Project configuration and stored target configuration are identical.

The description of the project configuration (SmartWire-DT configuration in XSoft-
CoDeSys-2 project) are provided in the Document «MN04802091Z-EN User Manual
XSoft-CoDeSys-2: PLC programming XV100», Chapter «SmartWire-DT configuration».