Eaton 93PM Integrated Battery Cabinet-Small Welded (IBC-SW) Installation Manual 164000639—Rev 03
23
C
Chhaapptteerr 44 IInnssttaallllaattiioonn
44..11
P
Prreelliim
miinnaarryy IInnssttaallllaattiioonn IInnffoorrm
maattiioonn
WARNING
Installation should be performed only by qualified personnel knowledgeable of batteries and the required
precautions.
Observe these precautions while installing the Integrated Battery Cabinet (IBC):
•
Remove watches, rings, or other metal objects.
•
Use tools with insulated handles.
•
Wear voltage rated gloves and electrical hazard footwear.
•
Do not lay tools or metal parts on top of batteries or battery cabinets.
•
Refer to
Chapter 3
Installation Plan and Unpacking
for cabinet dimensions and weight, wiring and
terminal data, and installation notes.
•
Do not tilt the cabinets more than 10° during installation.
Failure to follow these instructions may result in severe injury or death.
44..22
U
Unnllooaaddiinngg tthhee IIB
BC
C C
Caabbiinneett ffrroom
m tthhee P
Paalllleett
DANGER
RISK OF INSTABILITY. Do not remove any internal panels until the cabinet is removed from and lowered from
the pallet.
WARNING
•
The IBC is heavy (see
). If unpacking and unloading instructions are not closely followed, the cabinet
may tip and cause serious injury or death.
•
Lift the cabinets only with a forklift or pallet jack or damage may occur.
•
Verify that the forklift or pallet jack is rated to handle the weight of the cabinet (see
for cabinet
weight).
•
Do not tilt cabinet more than 10° from vertical.
Failure to follow these instructions may result in severe injury or death.
The IBC is bolted to a pallet consisting of four metal angle supports secured to two wood supports.
To remove the pallet:
CAUTION
Do not use the jacking bolts on a soft surface floor. Use only on a hard surface, such as concrete. If necessary
remove pallet on a hard surface and roll cabinet to final installation position.
1.
If not already accomplished, use a forklift or pallet jack to move the IBC to the installation area, or as close
as possible, before unloading from the pallet. Insert the forklift or pallet jack forks between the supports on
the bottom of the pallet (see
for the IBC cabinet center of gravity measurements).
