Test Menu
Page 115
Messages
Specify the text for the Home Message and for the additional four messages (Message 1-
4). Each message can have up to 30 characters.
Triggers
For each Message 1-4, specify the event categories that you want to associate with the
message. You can choose one or more of the following:
Alarms
Includes all types of alarm, including 24 hour, Fire, HUA, Burg, test zone fail, Zone
Alarm and Zone Follow. This also includes restores from those alarms. See page 61
for details of how Zone Alarm and Zone Follow are configured.
Tampers
Includes all types of tampers, including system, keypad, expander, sensor, user code
(excess digits), siren, WAM and radio keypad.
Sets/Unsets
Includes any type of setting, part-setting or unsetting of a partition (or part set) by
either keypad, remote control, or keyswitch.
System
Includes any type of system event that is not an alarm, tamper or set/unset. This
includes bus device missing, jamming, supervision fail, communications failure or
fault, AC lost, low or missing system battery, low battery on radio device and Aux 12V
fail.
Destinations
Use this option to specify the recipients of the reports:
1.
Select a Message 1-4.
2.
Select one of the four recipients. Each Message 1-4 can have up to four recipients.
3.
Select a contact from the Contacts List (page 102); the control unit will use the email
address of that contact.
4.
If required, repeat the process from step 2 to specify additional recipients for the
message.
5.
If required, repeat the process from step 1 for another Message 1-4.
Server
Specify the details of your mail server (available from the email provider):
Server Name
– The address of the outgoing mail server (e.g. mail.gmx.com).
Server Port Number
– The port number of the mail server (e.g. 587).
Account
– Your account name (e.g. [email protected]).
Username
– Your username to access the email account.
Password
– Your password to access the email account.
SSL
– Select Enabled if the mail SSL uses SSL.
Line Fail Response
Use this option to specify how the system should respond when the control unit detects a
line-fail fault on a communications path from the control unit. You can specify different
settings for Ethernet, plug-by and plug-on module communications.
