Eaton i-on Compact, Руководство пользователя

Страница: 7 / 12

Page
7
To silence, acknowledge and reset an
alarm:
1. Make sure that it is safe to enter the
premises.
2. Enter your access code or present your
proximity tag in the normal way. This
silences the alarm (if the sirens and
sounders are still operating).
3. The navigation key glows red and the
display shows, for example:
Press tick to reset
Zone 000
The display alternates between
showing the zone number (e.g. “Zone
000”) and alarm type.
4. If you see “reset” in the message (see
above):
• Press

− this acknowledges the
alarm and resets the system. The
system returns to standby and is
ready to set again. The navigation
key returns to its normal (green)
state.
If you see “Call Installer” or “Call ARC”
at the top of the screen:
• Press

− this acknowledges the
alarm, but you will need to call the
installer or ARC to reset the system.
Although the system is not reset, you
will still be able to set and unset the
system normally. The navigation key
and applicable set/unset icons stay
red until the alarm is reset.
If you see “RESET FAULTS”, call your
installer.
Accessing the User menu
The User menu gives access to user
options such as to omit zones, view log
information and add new users. The range
of options available to you depends on
your user type (privileges).
To access the User menu:
1. Make sure the display shows the
standby screen.
2. Press .
3. Enter your user code:
Enter Access Code:
(* )
The first option is displayed:
MENU
Omit Zones >
Press

or

to scroll through the
options, followed by

to select the
option you require. The options are
fully documented in the Administration
and User Manual.
4. To leave the menu and return to the
standby screen, press

(if necessary
several times).
Omitting zones
Omitting a zone prevents it from
generating an alarm if the zone is triggered
while the system is set. You may, for
example, want to omit a zone that protects
a garage to enable access without causing
an alarm while the system is set.
Note: The zone returns to normal operation
when the system is unset.
Note: You can omit only those zones that
the installer has specified can be omitted.
To omit zones:
1. Access the User menu, as described in
the previous section.
2. Select the
Omit Zones
option. The first
zone you can omit is displayed. For
example:
OMIT ZONES
Zone 000 I
An “O” is displayed at the end of the
line if the zone is Omitted. An “
I
” is
displayed if the zone is Included.
3. Press

or

to display the zone you
wish to omit, then  to mark it for
omission. Press  again if you made