Eaton i-on Compact, Руководство пользователя, Страница: 6 / 12

Page
6
Carries out a full system set*.
Sets part set B, C or D*.
A Hold Up Alarm (HUA) is
started when both of these
keys are pressed (if enabled
by the installer).
*This is the default action; the installer can
configure these keys to operate outputs.
About the standby screen
When the system is idle (either while set
or unset), the display shows the “standby
screen”. For example:
i-on Compact
10:43 03/06/2017
Setting the system
Readying the system to start an alarm if
someone moves into a protected area is
called “setting” the system.
You can set your system using a variety of
different methods, depending on system
configuration. The following explains a
typical method using the control unit.
Note: Please refer to the Administration
and User Manual for full details.
1. Enter your access code or present your
proximity tag at the control unit. If you
enter your access code, the display
shows a * for each completed digit:
Enter Access Code:
(* )
2. If setting options are displayed, you
can press

or

followed by

to
choose the option you require:
Setting Options
Full Set
•
Full Set
: To set the whole system.
Alternatively, press the A key*.
•
Part Set B\C\D
: To set part set B, C or
D only. Alternatively, press the B, C
or D key*.
*Your installer may have configured
the system to allow you to quick set
using A, B, C or D without entering an
access code or presenting a proximity
tag first.
3. You will hear a continuous exit tone
(unless the system is configured for
silent or instant setting).
The system sets when one of the
following occurs, depending on how
the system is configured:
• Immediately.
• After a period of time.
• When you exit the premises.
The A (full set), or B, C or D (part set)
key illuminates to indicate the set
status (unless disabled by the installer).
Unsetting the system
Disarming the system so that people
can move freely is called “unsetting” the
system.
To unset the system from the control unit:
1. Enter through the designated entry
route. Do not stray from this route –
you may cause an alarm.
2. If you hear a tone, go directly to the
control unit, since you will have limited
time to unset the system before it
generates an alarm.
3. Enter your access code or present your
proximity tag.
Managing alarms
If there is an alarm, you will need to
silence the sirens and sounders (if they are
still running), acknowledge the cause of the
alarm and reset the system.
Note: Please refer to the Administration
and User Manual for full details.