9
GREEN MOTION DC 22 EV CHARGER USER MANUAL
MN192003EN October 2022 www.eaton.com
4. How to start and stop charging
Electrical systems or devices must be checked by the installer of the system before commissioning and
switching on the unit for the first time.
Follow these steps to charge:
Step 1.
Check that the EV charger is ready for use with the LED in green. See Chapter 5.
Step 2.
Hold the cable connector of the EV charger and plug it to the appropriate car socket.
Step 3.
If the EV charger is equipped with a RFID reader place the RFID card close to the reader to authenticate yourself.
If the card is recognized, the LED starts flashing blue and after it shows the level of state of charge (see Figure 4).
If the CHAdeMO plug is used, this is mandatory for the user to select the plug on the screen. Refer to the next sections.
If the card is not authorized, the charge will not start, and a red indication is displayed on the charging station display.
See Chapter 5.
If the charging cable is disconnected from the car and there is no power consumption within two minutes, the user is
automatically deauthenticated.
Figure 4. Where to place the RFID card on the EV charger for user authentication
While your vehicle is charging, the EV charger display shows the LED as charging with a breathing blue light. See
Chapter 5.
When the battery is fully charged, the EV charger display shows the LED in a steady blue light as fully charged. See
Chapter 5.
Step 4.
To stop charging, unplug the connector from your vehicle. Usually, the connector must be released from inside your
vehicle first. See the instruction manual of your vehicle.
RFID
