5
INSTALLATION INSTRUCTIONS
MN280091EN April 2018
Form 4D Recloser Control Communications Module
14. A second communications module can be installed in
the lower slot (Com Port 2) (
Figure 13
) or the supplied
cover can be placed over the slot if it is not needed
(
Figure 14
). Either the module or cover should be
secured with two of the #6-32 screws supplied with
the kit.
Figure 13 . Two communications modules installed
Figure 14 . One communications module installed with
the other slot covered
Install module
CAUTION
Equipment misoperation . Do not connect this control
to an energized recloser until all control settings have
been properly programmed and verified . Refer to the
programming information for this control . Failure to
comply can result in control and recloser misoperation,
equipment damage, and personal injury .
G110 .3
1. Align the bottom lip of the module with the lower edge
of the swing panel.
2. Position the ground link on the swing panel to line up
with the ground lug on the module as it moves into
position (
Figure 2
).
3. Lift up on the module until the ground link slides into
place and continue lifting up until the module is firmly
back into the swing panel.
4. Press into place as necessary.
5. Slide the retaining bar down all the way over the
module’s aluminum extrusion as much as possible.
6. Torque the three (3) nuts to 24 in-lbs (
Figure 1
).
7. Torque the nuts on the ground link to 24 in-lbs.
8. Reconnect all wire connections to the side of the
module.
9. Reconnect the battery (if used).
10. Reconnect AC input power to TB1 or to AC input
receptacle, if applicable.
11. Verify the module powers up properly.
12. Download the desired settings to the control.
13. Verify control operation before returning to service.
Refer to
MN280049EN
.
14. Refer to
Service Information MN280086EN Form 4D
Control Communications
for more information on
the operation of the communications equipment and
programming the control for communications.
