ESWA4500C
Multi-Source Volume Control Module
Installation Manual
Control functions [1] [2] [3]
System ON
- The EATON A-BUS system will activate if any function button is pressed.
Input Selection [1]
- The system will restart on the last source selected. One of the four input
LEDs [5] will indicate which input has been selected. The input can be changed by pressing
left or right buttons [1].
Volume Level [2]
- If the system has been switched off the Volume Control will restart at low
volume level. If the system has remained active the Volume Control will return to the
previously selected volume level. The level may be adjusted by pressing the Up/Down
buttons [2]. While the level is being adjusted, the input LEDs [5] will ripple left or right.
Remote Control [4]
- The Volume Control may be operated by remote control. The IR remote
must have clear line-of-site to the IR Receiver. The Volume Control can also relay IR remote
control commands to the hub and connected source components. It will repeat standard 38
kHz commands and 56 kHz commands which are often used in satellite receivers. You may
experience difficulty with some remote control commands on some components. The
operating range can be affected by sunlight and some lighting systems.
Off and All Off [3]
- A Volume Control can be switched off individually by pressing the off
button, this will turn off the backlighting to the volume control [2] and input selection buttons
[1]. The backlighting of the off [3] and input indicator will [5] remain on. If there are other
Volume Control’s connected to the same zone their status will not be affected. If the off button
[3] is pressed for more than three seconds the whole A-BUS system will turn off. When the
system is off the infrared relay system will remain active.
Backlight adjustment [6]
- The backlighting level of the function buttons [1] [2] [3] can be
adjusted to individual requirements.
This Keypad Volume Control Module has been
designed to work with intelligent EATON A-BUS
Multi-Source Hubs using standard A-BUS commands.
It will operate with other single source and multi-source
hubs, however, some functionality such as source
selection maybe not be available.
These functions can be accessed with a remote control
handset containing the correct codes.
Note:
For comprehensive instructions please also refer
to the instructions supplied with your EATON A-BUS
multi-source hub.
