Eaton ESWA4500C Скачать руководство пользователя страница 2

A-BUS is a registered trademark of LeisureTech Electronics Pty Ltd.

All features and specifications are subject to change without notice.

All trademarks property of their respective owners.

Installation 

It is recommended that your EATON Volume Control is installed by a qualified installer to ensure 
that the installation is carried out correctly and it complies with all relevant installation regula-
tions. The Volume Control should not be installed next to or in the same box as high voltage 
devices. The Volume Control is connected to the hub via a single category 5 cable, it is recom-
mended that it should not be run parallel or close to high voltage cables or data cables, etc. 
The EATON Volume Control is designed to fit into a single Gang bracket. The category 5 cable 
from the hub should be properly connected to either the 110 punchdown [7], using a proper 
installation tool. It is recommended that the category 5 cable length be no longer than 100ft. 
(30M), longer runs may induce noise and reduce sound quality. The speaker cable terminal [8] 
will accept up to 14 gauge cable. 
Set-up [9] - The A-BUS installation should be completed with all power modules connected but 
not installed into the walls. Follow these steps to give you maximum control flexibility over the 
volume of your A-BUS system. On the back of the power modules there are trim pots (Left & 
Right) [9] that fine-tune the output level to compensate for the length of the cable run, the 
efficiency of the speakers and the size of the room. There are also situations where you may 
want to limit the output level in a particular room. With the trim pots adjusted to minimum, the 
main volume control should be adjusted to maximum level, then with popular music playing the 
trim pots should be brought up to a point just below the amplifier’s clipping level. (Clipping is the 
point where the sound starts to distort). When the trim pots are all set to the desired level the 
installation may be completed. 

Mini Remote Control Handset ESWA100CR

The mini remote control handset supplied contains basic A-BUS remote control commands, 
volume Up/Down [10] up to 4 individual input selections [11] Off [12] and All Off (Global) [13]. In 
good conditions this handset should have an operating range of up to 70ft. (20M), in poor 
conditions such as bright sunlight it maybe less than 15ft. (5M). 

42mm

BACK

ESWA100CR REMOTE CONTROL

SUPPLIED

PUNCHDOWN VERSION SHOWN

FRONT

70.25mm

106mm

42.75mm

71mm

L-     L+

R+     R-

SPEAKER OUT

BR  BRW BL  BLW  GR  GRW OR  ORW

LEVEL ADJUST

L CH      R CH

l

2

3

ESWA100CR

4

UT

Отзывы: