12
InstallatIon anD opERatIon manual
25-17603-C
March 2023 www.eaton.com
5. Commissioning Beam Detector
5.1. Commissioning Preparation
1. Make sure both beam detector and reflector are mounted correctly and
secure.
2. Make sure that there is a clear line of sight between the beam detector and
the reflector and the alignment angle is correct.
3. Make sure that the correct number of reflectors are installed for the distance
covered.
4. Make sure the Span settings are correct for the distance covered, these are
adjusted through the DIP Switch depending on the distance between the
detector and reflector. [Span1:8-20meters; Span2:20-40meters, Span3:40-
70meters, Span4:70-100meters].
5. Confirm cable terminations are correct.
5.2. Step 1: Entering Commissioning Method
A. Remove the detector cover and power on the device.
B. Place the supplied magnetic tool alongside the Reed Switch. After a while
the Green LED [HL1] should turn on steady or blinking, and then take out the
magnetic tool to start the detector auto alignment process.
ote:
n
Keep the line of sight clear between the detector and reflector. Do not disturb
the detector auto alignment process.
5.3. Step 2: Sightline Alignment Procedure
A. The Laser Beam Pointer should turn on automatically. Look at the reflector
and check to see if the laser is pointing at the centre.
B. Once you have located the mark, loosen the M4x12 screw and adjust the
horizontal or vertical adjustment wheel until the Laser is pointing at centre
of the reflector. Refer to figure 8.
ote:
n
During the adjustment period the digital display guide indicates a number- it is
not indicating the signal intensity. If the number turns to zero [0] it means the
Sightline Adjustment is not appropriate and more adjustment is required.
5.4. Step 3: Acceptable Adjustment Procedure
A. Adjust the signal intensity through the horizontal or vertical adjustment
wheel monitor the signal intensity through digital display guide, the number
is indicating the signal intensity from 1 to 8. Try to reach number eight [8]
to achieve acceptable adjustment. However, for long path span number 2
or 3 is an acceptable adjustment. Make sure that the line of sight is clear
between the detector and reflector.
