Eaton EASY222-DN, Руководство пользователя

Страница: 42 / 284

DeviceNet functions
38
09/10 MN05013007Z-EN
easy Object
The easy object can be used to access easy/MFD functions
via the DeviceNet communication bus. The table below
shows the attributes supported by this object. The 2 bytes of
the attributes 1 and 2 give the diagnostics data of the device.
Attribute 3 can be use to access the outputs (S1 to S8) and
attribute 4 to access the inputs (R1 to R16) of the basic unit.
By using a DeviceNet configuration software (e.g.
RS NetWorx), you can map these data directly to the corre-
sponding memory areas of a PLC.
Table 4: Attribute IDs of the Easy Object instance
Object address Function Access
Class ID Instance ID Attribute ID Service code
64
hex
01
hex
a table 4 a table 5
Attribute
ID Access Name Description Size
[byte]
1 Read easy Status This attribute can be used to read the
status of easy (RUN or STOP).
a table 6
1
2 Read Coupling
Module
Status This attribute can be used to read the
status of easyLink.
a table 6
1
3 Read Inputs – Send
Data easy transfers the input data to the Devi-
ceNet bus. The easy outputs S1 to S8 must
be used for this function. The structure of
these 3 bytes is described in detail under
Section “Input data: Mode, S1 – S8”,
page 49. 3