UK
7
UK
Put the control unit/receiver into learn mode (consult the relevant section in the control
unit/receiver
’s Installation and Programming Guide).
Radio Learning Press and hold the test button for three seconds. The detector
transmits its identity by radio (and also gives the alarm tone).
Infra-red Learning Remove the batteries. Hold the detector so that the activity LED
points at the IR learn sensor on the receiver. Make sure the activity
LED on the detector is as close as possible to the IR learn sensor.
Wait at least 60s after removing the batteries and then re-fit the
batteries. (This ensures that the DET-RSMOKE starts up correctly.)
The activity LED flashes eight times. The infra-red part of the light
carries the detector
’s identity to the learn sensor.
Activity LED Control
During normal operation (when the unit is
not in alarm) the activity LED flashes once
about every minute. It is possible to disable
this feature by operating the Dip switch
a)
next to the batteries, see Figure 4.
a) Activity LED flashes once about every
minute during normal operation.
b) Activity LED does not flash.
b)
Figure 4
