3 8
P a n e l M a t e e P r o P S U s e r s G u i d e
If the calibration is acceptable, select the
OK
button or the exit shortcut button (
X
) at the
top of the window to temporarily save the new calibration. If the calibration is not correct,
reselect
Standard Calibration
and repeat the operation until satisfied.
If desired, you can select the
Advanced Calibration
button. This feature will let you
select the number of calibration points and a display of the calibration data for increased
accuracy.
Calibrating Blind Node Models
PanelMate ePro PS Blind Nodes include an Elo touchscreen driver that loads
automatically at startup. If for some reason you find it necessary to re-calibrate the
touchscreen, you can do so by selecting
Start>Settings>Control Panel
and then
selecting the
Elo Touchscreen
program. Doing so launches the
Elo Touchscreen
Properties
dialog box. Select
Calibrate
in the
General
tab to start the calibration
process.
Note:
On the
General
tab, the Touchscreen Port will have a default value of COM2. If
you need to reserve COM2 for communications, change the value to COM1.
Once you start the calibration process, a crosshair on a red and white target appears in
the upper-left corner of the display. While in your normal operating position, touch the
crosshairs in the middle of the target. The crosshairs will move to the lower-right corner
of the display. Touch the crosshairs again, and the crosshairs will move to the upper-
right corner of the display. After touching the upper-right crosshairs, a
Check
Calibration
dialog box will appear, informing you that you have 30 seconds to confirm
the calibration. Touch points on the screen to confirm the arrow cursor is tracking as
desired and then select
YES
(if the calibration does not look correct then select
NO
and
re-calibrate the screen until you are satisfied). Once you select
YES
, you are returned to
the
Elo Touchscreen Properties
dialog box. Close the
Elo Touchscreen Properties
dialog box by selecting the
OK
button. The calibration settings will be temporarily saved
at this time.
Close the
Control Panel
window by selecting the exit shortcut button (
X
) at the top of
the window.