![background image](http://html1.mh-extra.com/html/eaton/cutler-hammer-panelmate-epro-ps-7685t-12/cutler-hammer-panelmate-epro-ps-7685t-12_replacement-procedures_3747924009.webp)
February 2006
Page 9 of 9
01-50605-00
27. Reconnect the touchscreen cable to the CPU circuit board and reattach the touchscreen cable cover
28. Tywrap the red and black wires (coming up from the bottom of the board) to the cable harness on the
power supply. Ensure the red and black wires fit in the slot between the power connector and the
metal bracket on the CPU circuit board. Reconnect the red and black wires to the power supply. Red
going to the +24V screw terminal and black going to the 0V screw terminal. See Figure 5.
29. Reattach the power supply. See Figure 4 and Figure 3.
30. Reattach the standoffs in the four corners of the CPU circuit board. See Figure 2.
31. Verify that all previous connections are in place and that all wires are under the CPU circuit board.
Reinstall the chassis cover. See Figure 1.
32. Connect the power source cable and any other cables.
Eaton Corporation
Operator Interface Business
811 Green Crest Drive
Westerville, Ohio 43081
tel: 614-882-3282
fax: 614-899-5390