Eaton Cutler-Hammer J-Frame Series, Инструкция по установке

Страница: 3 / 12

I.L. 29C211E
Effective 04/04
in the OFF position. The switch is held closed when the
cover is in place and the padlock bracket is in the non-
padlockable position.
2-0 INSTALLATION
The electrical operator is normally supplied as a sepa-
rate item for mounting on an uninstalled circuit breaker.
If an electrical operator is to be mounted on an installed
circuit breaker, all power must be removed from the cir-
cuit breaker before proceeding to mount the electrical
operator.
The installation procedure consists of inspecting and
mounting the electrical operator and connecting control
wiring. To install the electrical operator, perform the fol-
lowing steps:
BEFORE MOUNTING AN ELECTRICAL OPERATOR
ON A CIRCUIT BREAKER INSTALLED IN AN ELEC-
TRICAL SYSTEM, MAKE SURE THE CIRCUIT
BREAKER IS SWITCHED TO THE OFF POSITION
AND THAT THERE IS NO VOLTAGE PRESENT
Figure 1-3 Circuit Breaker Handle in CLOSED Position
Armature
Drive
Plate
Molded
Trigger
Magnet
Coil
Assembly
Logic
Control
Cutoff
Switch
Magnet
Drive
Plate
Bi-stable
Latch
Magnet
Coil
Assembly
Circuit Breaker
Handle
(CLOSED Position)
!
WARNING
Figure 1-4 Electrical Operator Connection and Schematic Diagram
Logic Control
Cutoff Switch
➀
PB1
PB2
M1
M2
COM
OFF
ON
(-)
COIL
GND
F1
F1
C1
C2
S1
(+)
COIL
S2
Solenoid
Coil
Solenoid
Coil
Cover Lockoff
F1 Fuse (Supplied by Customer)
PB1, 2 Pushbutton (Supplied by Customer)
C1/M1 Operating Contactor
C2/M2 (Supplied by Customer)
➀
Electrical Rating 10A at 125 Vac, 5A at 250 Vac
Page 3