![background image](http://html1.mh-extra.com/html/eaton/cooper-power-series/cooper-power-series_installation-and-operation-instruction-manual_3719793029.webp)
Installation procedure
CBC-8000 capacitor bank control installation and operation instructions
MN916001EN—October 2018
Eaton.com
23
8-Pin DIN connector (sensor inputs only)
The 8-pin DIN connector is only used for connecting sensor
inputs to the control. This DIN option facilitates retrofitting a
new control to an existing installation. The 8-pin DIN
connector offers 3-phase voltage and current
measurements, and support for a neutral current sensor.
This DIN option may be added to four-jaw, six-jaw, 5-pin DIN,
or 7-pin DIN control configurations to provide 3-phase
measurements and neutral current sensing.
Note:
The 8-pin DIN connector does not offer trip and close
functionality.
The 8-pin DIN signal assignments are as follows:
Pin
Signal
A
Voltage A
B
Voltage B
C
Voltage C
D
Current A
E
Current B
F
Current C
G
Neutral Current
H
Neutral/Common
An example of the 8-pin DIN male connector with the pin
locations is shown in Figure 24.
The CBC-SENCBL8P-40 wiring harness from Eaton’s Cooper
Power series is designed for use with the control’s 8-pin DIN
connector, see
Wiring harness options on Page 24
.
Figure 24. 8-pin male DIN connector.
14-Pin DIN connector (3-phase metering/control)
The 14-pin DIN connector includes powering and operating
the control, 3-phase voltage and current measurements as
well as connections for a neutral current sensor. All the
available CBC-8000 control options are provided in this DIN
connector.
Note:
Two pins of the 14-pin DIN connector are not used by
the control. This is a 14-pin connector that only uses
12 pins to operate the control.
The 14-pin DIN signal assignments are as follows:
Pin
Signal
A
Line
B
Neutral/Common
C
Trip/Open
D
Close
E
Voltage A
F
Voltage B
G
Voltage C
H
Current A
I
Current B
J
Current C
K
Neutral Current
L
Not Used
M
Neutral/Common
N
Not Used
An example of the 14-pin DIN male connector with the pin
locations is shown in Figure 25.
The CBC-CTRLSEN14P-40 wiring harness from Eaton’s
Cooper Power series is designed for use with the control’s
14-pin DIN connector, see
Wiring harness options on Page
Figure 25. 14-pin male DIN connector.
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
I
J
K
L
M
N
Содержание COOPER POWER SERIES
Страница 49: ......