Eaton BreakerVisu NZM-XMC-MDISP35-MOD, Руководство пользователя

Страница: 47 / 88

7 Measured value logging
7.3 Device data logging
BreakerVisu 06/16 MN01210001Z-EN www.eaton.com
45
Table 42: Energy logging – File names
￫ Section 15.3, “Format for measured value fi les”, page 64 provides an
example of a power monitoring file. The actual format will depend on the
BreakerVisu variant being used and will reflect the number of connected
devices.
7.3 Device data logging
Data logging is carried out at the device level and needs to be started
manually.
To start data logging at the device level, please follow the steps below:
▶ Go to the device details screen for the device you want
(
￫ Figure 8, page 19 and ￫ Figure 12, page 21).
▶ Go to the Logging screen ( ￫ Figure 11, page 21 and ￫ Figure 16,
page 23).
▶ Set the measuring interval you want (scan rate).
▶ Start the measuring function.
Table 29, page 31 describes the corresponding user interface screen.
7.3.1 Logged parameters
Table 47, page 58 provides a list of the parameters being logged. The values
in the log file will be calculated as the average value for the corresponding
logging interval.
7.3.2 Setting a scan rate
To set the time interval for sampling, go to the Logging sub-screen in the
device details screen. The minimum possible interval between two
measurements is 10 s, i.e., logging data at measuring intervals shorter than
10 s is not possible. If you need faster logging for specific devices, enable
the
Fast Logging option (logging interval: 2 s).
￫
￫ Section 2.6, ““Energy Logging” screen”, page 25 explains
how to configure the power monitoring data.
Measuring
interval File name
15 minutes
BV_energy_15m.csv
Hourly
BV_energy_h.csv
Daily
BV_energy_d.csv
Weekly
BV_energy_w.csv
Monthly
BV_energy_m.csv
Annually
BV_energy_y.csv