Sync Control for Eaton 9395P and 93PM
8
User’s and Installation Guide
2
Installation Plan and Unpacking
The Eaton Sync Control is shipped as a separate item and can be mounted on any surface that
can safely bear its weight. See paragraph 2.2 for weight, dimensions, and wiring preparation.
2.1
Creating an Installation Plan
Before installing the UPS system, read and understand how this manual applies to the system
being installed. Use the procedures and illustrations in the following chapters to create a logical
plan for installing the system.
NOTE
Startup and operational checks must be performed by an authorized Eaton Customer
Service Engineer, or the warranty terms specified on page 33 become void. This service is
offered as part of the sales contract for the UPS. Contact service in advance (usually a
two week notice is required) to reserve a preferred startup date.
2.2
Preparing the Site
For the Eaton Sync Control to operate at peak efficiency, the installation site must meet the
environmental parameters outlined in the applicable Eaton 9395P or Eaton 93PM User’s and
Installation Guide that are listed in paragraph 1.3 on page 7.
2.2.1.
Environmental and Installation Considerations
The life of the Eaton Sync Control is adversely affected if the system is not installed in a
temperature and humidity controlled indoor area free of conductive contaminants.
Failure to follow guidelines may void your warranty.
Attach the Eaton Sync Control to the wall with appropriate fasteners and washers. The Eaton
Sync Control includes 4 x 8mm mounting holes as shown in Figure 2-1. As wall materials vary,
fasteners for fixing to the wall are not included.
The equipment operating environment must meet the weight requirements shown in Table 2-1
and the size requirements shown in Figure 2-1 and Figure 2-2. Dimensions are in millimeters
(inches).
Table 2-1 Equipment Weight
Eaton Sync Control
Shipping
Installed
Weight [kg] (lbs)
33,4 (73,6)
30,1 (66,4)