(3)
The distance is too close:the “silks” are irregular protrusion(with burrs)on the both
sides,but thin in the middle. Or there are no silks coming down. Or the bed is scratched
with a deep trace .
Q7:Why do there twist lots of filament nearby the nozzle in the process of printing?Model
become mess of silks?
A:there are several situation:
(1)
When it happens in the initial printing,the distance between nozzle and bed is too far,
the silks can not stick to the bed ,so it would become messy filament.Please twist the 4
bed screws 90 degree anti-clockwise.If still not ok , then please twist 90 degree
anti-clockwise again till normal printing.
(2)
The bed is with oil,please use dry towel to tidy the bed,do not use hand to touch the
bed directly.
Q8:How can i move the printing head?
A:Please unplug the power,then use hand to move the printing head to where you want.
Please do not try to move the head up and down, move along Z axis can not realized by
hand.
Q9:How can i move the printing head up?
A: choose “move axis “ columns on the screen, you can move X, Y, Z axis
Q10:Does the printer need warming up before each printing?
A:There needs to warm up when feed and retract operation,In the normal printing, you
only need to choose the model and wait about 1 minute,then printer will start work.
Q11:Can the model continue printing if electricity is cut off?
A:If there is no electricity in the process of printing, the models can not continue printing.
Q12:Can pause printing in the process of printing?
A:Yes, press the screen control button, it will pause. Then press again,it will continue
printing.
Q13:How to stop printing?
A:Please press the screen control button, choose stop printing,
