Caution
• Do not allow dry operation
• Do not allow foreign objects to enter intake
• In case of power outage, turn off power switch to avoid damage when power
resumes
• If excessive vibration occurs turn off power immediately
Protection System
The motor has a built in protection system which stops the pump when overheating
occurs, due to excessive load. Load could be caused by clogging at inlet or outlet
and when a fluctuation in the power supply occurs.
Water Level
• Never operate below minimum water level which is 6" above base level (about half
way submerged)
• Continuous operation water level is at least 14" above base level (submerged)
• Operate for a maximum of thirty minutes if water level is between 6" and 14"
Inspection
• Always turn off power and remove power outlet plug from power outlet before
performing inspection
• Check regularly for drop in performance and remove any clogged material from
inlet area, outlet hose and pipe
• Check and tighten nuts and bolts if required
• Check with dealer for advice on other repairs
Pump Storage
• When the pump is out of use for an extended period - wash it, dry it and store
indoors
• Do not leave pump outdoors in freezing conditions
• If the pump is left in water but not operating regularly, test run it at least once a
week
Disassembly and Reassembly
• Do not attempt to disassemble pump during warranty period
• If impeller replacement is required, contact dealer for service
3
