EASYLOOK ES10-01, Руководство по эксплуатации

Страница: 64 / 76

59 Easylook Video Assist Operation Manual
Easylook Video Assist Operation Manual
By selecting channel 0 it is possible to disable only the video transmitting module of the ES1S-02.
The unit itself stays powered on. This is important when the video transmitter ES1S-02 is used in an
environment where transmitters are not permitted and you would like to use the automatic recording
or playback with camera speed function via cable.(for more information, see
Playback with camera
speed and Automatic Recording)
Switching off the whole transmitter ES1S-02 unit
As soon as the transmitter ES1S-02 is connected to a power source via autorecord cable it powers
up and starts transmitting a video signal. To switch off the unit, press the ( M ) key.
è The video transmitter ES1S-02 emits radio frequency electromagnetic energy lik e other radio
devices. However, the level of energy emitted is far much less than the electromagnetic energy
emitted by wireless devices lik e for example mobile phones.
7.5 Micro Transmitter ES1S-11
The micro transmitter ES1S-11 is a very small and light weight wireless video transmitter to be
attached to a camera. It transmits the video signal to compatible receiving units. (e.g. single receiver
ES01S-04 or an Easylook video assist main unit). It is the perfect video transmitter for steadicam or
handheld camera work.
(N) wireless channel selector
II. Antenna connector
XI. Power/Video connector
Setup
Attach the antenna MTR AE01-03 to the antenna connector ( II. ) of the micro transmitter ES1S-11.
Then connect the video signal source and the power cable to the Power/Video In connector ( XI. ) of
the transmitter using the according power/video combo cable. (for more information, see Cables )
Make sure that the receiving unit and the micro transmitter ES1S-11 use the same transmitting
channel.