FIG. 3
FIG. 4
PANTONE 072 C
PANTONE 123 C
Customer service: 0871 855 6100
For more innovative products from Easylife please visit:
www.easylifegroup.com
Attaching the steam head
Slide the bottom end of main body (A) into the handle cavity (B) and click into place. The main body (A)
can easily be removed from the handle cavity (B) carefully lifting the lock catch (6).
Attaching a cleaning pad
Carefully remove the carpet glider (N) from the steam head (M) by pulling the two barb-clips on the
carpet glider and separating the two parts.
Place a microfibre floor cleaner (K) over the grippers on all three sides.
Replace the carpet glider (N) over the steam head (M) and microfibre floor cleaner (K) and click
into place.
Attaching the Steam Head
Insert the steam head (M) into the handle (B) (as shown in Fig 2), please ensure that the barb connector
on the steam head is in the correct position when connecting the two parts. Once connected the two
parts will click into place.
OPERATION
1. Filling the water tank
Method one: Open the water tank by turning the knob anti-clockwise and fill 360ml of water using the
measuring cup (J). Replace the knob by turning clockwise to close water tank (see Fig 3).
Method two: Remove the water tank from main body, open the water tank by turning the knob anti-
clockwise. Fill the water tank from a tap the then replace the knob by turning it clockwise
(see Fig 4).
2. Plug in the steam mop into the mains outlet.
3. When you switch the appliance on the indicator LED lights will turn red at the each side of water tank,
this will indicate the water in the tank is pre-heating.
4. It will take approximately 25 seconds for preheating to complete. Once the steam mop is ready to use
the water tank will glow blue.
FIG. 2
COMPONENTS
1
Spindle Button
2 Handle
3
Cord Holder
4
Handle Steam Button
5
Steam Head Spindle
6
Lock Catch
7
Main Body Steam Button
8
Power Cord
9
Power Switch
10 Indicator Light
11
Water Inlet
12 Steam Control Knob
13 Water Tank Cap
14 Water Tank Button
15 Water Tank
ASSEMBLY
WARNING: Before attempting any of the following operations, make sure that the appliance is switched
off and unplugged and that the appliance is cold and contains minimal or no water.
Handle
Push the spindle button (1) and fully extend the handle (2) until it clicks into place See Fig 1.
FIG. 1
