EasyIO FG-32, Руководство по установке

Страница: 6 / 20

EasyIO FG32 – Installation Guide v2.0
6
Introduction
EasyIO FG Series is the most powerful Sedona controller in the market. It is equipped with two 32-bit
Processors, the first in the Automation industry, with an ARM9 200 MHz Samsung processor (400Mhz for
FG+ Series), an ARM M3 Cortex for the I/O management and A-D processing, and also with a Linux 2.6 OS
for premium performance. Later in 2013 we will be adding Graphics capability to serve up html templates
that will be stored on the Micro SD card. BACnet and Modbus enable. TCOM Niagara integration is
available and is encouraged for premium performance with Niagara Framework.

The Build in boot loader enable firmware upgrade to be carried out remotely. No more
manual service button needed is used.



Firmware upgrading now can be done remotely and without any assistant.


Document applies to both FG Series and FG+ Series, both 20 points and 32 points hardware.
Comparison Chart below shows the difference between EasyIO FG-32 and EasyIO FG-20.
The FG+ series has a upgrade processor with 400 Mhz CPU while the FG series has only 200 MHz
processor.
Item FG-32 FG-20
Digital Output 8 Channels 2 Channels
Universal Output 8 Channels 6 Channels
Universal Input 16 Channels 12 Channels
Table shown above show the different between EasyIO FG-32 and EasyIO FG20in terms of IO point.