EASYHOME MS-201, Руководство пользователя, Страница: 8 / 42

User instructions
8
Operating the sewing machine
With the foot pedal:
1. Make sure the machine is in the ‘OFF’ position.
Please Note: When using the foot pedal, the Power Button (P) should always
be in the ‘OFF’ position.
2. Plug the foot pedal plug into the Foot Pedal Jack (Z) located on the side of
machine.
3. Place the foot pedal on the ground.
4. Raise the Presser Foot (D) by lifting up the Presser Foot Lever (V) on the back
of the machine. The presser foot will raise slightly.
5. Position fabric to be sewn under the presser foot with presser foot in raised
position.
6. Lower the Presser Foot (D) by releasing the Presser Foot Lever (V) downwards.
7. Rotate the Hand Wheel (W) in a clockwise direction at least once, until the
needle is inserted into the fabric.
8. Select speed by pressing Speed Button (Q) on the front of the machine. When
the button is pushed in, that is Low speed. When the button is extended out,
that is High speed. Use low speed for intricate work which requires a lot of
stopping, starting and turning fabric. Use high speed for long uninterrupted
seams.
NOTE: The High speed is fast. It is suggested to start on Low speed until you
are comfortable to move on to High speed.
9. Press gently on the foot pedal to run the machine.
10. Gently guide the fabric to keep the seam straight by pressing lightly down
with your fingertips on both sides as it feeds through the Presser Foot (D).
11. There is no reverse button with this machine. If you need to turn the fabric
while stitching, turn off machine when needle is still in the fabric, raise the
foot pedal, and rotate the fabric in desired direction. Lower foot pedal and
continue stitch.
12. When the seam is finished, turn machine ‘OFF’.
13. Raise the needle out of the fabric by turning the Hand Wheel (W) slightly in a
clockwise direction.
14. Raise Presser Foot (D) by lifting the Presser Foot Lever (V).
15. Pull fabric towards you leaving about 5 inches of thread between the fabric
and the machine.
16. Cut thread loose to from machine by using the Thread Cutter (U).
17. Begin the next seam in the same manner as above.