8
Hold for 10s
•
•
E
very apartment must have a unique identification called the User Code (address).
DIP switches are used to configure the User Code for each Monitor.
Bit-1 to Bit-5 are used to
set the User Code. The values are from 1 to 32, giving 32 different
codes for 32 apartments.
•
When multiple monitors(4 max) are installed in one apartment, these monitors have to use
the same User Code setting and the Master/Slave mode should be set on the Monitor.
Bit-6 is line termination switch (EOL), this has to be set to ON if the Monitor is at the end of
the line(bus), otherwise set to OFF.
11.8 User Code Setup
Flashes slowly (enabled)
11.7 How to enable/disable auto unlocking (Disabled by default).
Function Description:
Auto unlocking
allows the door to unlock after 5 seconds of a placed call from the door
station without the need to answer or unlock the door, this allows the user to 'leave the
door on the latch' for a known visitor.
To Enable this function; from the installation page enter the following:
9018 is used to Enable the function - 'AU FUNC ON' will show on screen.
9017 is used to Disable the function - 'AU FUNC OFF' will show on screen.
