Easy Radiant Works Middleman EZM-90-40, Руководство пользователя

Страница: 9 / 40

9
WARNING
VENTING
Inadequate venting of a heater may result in asphyxiation, carbon monoxide poisoning,
injury or death. The heater may be directly or indirectly vented from the space. Venting
must be in accordance with all local, state, provincial, and national codes (ANSI
Z223.1/NFPA 54 in USA; B149.1 in Canada) and as indicated in this manual.
WARNING
START-UP SMOKE CONDITION
During start up, the heating of material coatings used in the production process of tubes
and reflectors will create smoke during the initial period of operation. This condition is
normal and temporary. Ensure that there is sufficient ventilation to adequately clear any
smoke from the space. Notify site and safety personnel to ensure that alarm systems
are not unduly activated.
LABOUR REQUIREMENTS
Two persons are required to safely install this equipment. Wear gloves and other
required safety protection.
INSTALLATION IN COMMERCIAL AIRCRAFT HANGARS
Low intensity radiant tube heaters are suitable for use in aircraft hangars when installed
in accordance with the latest edition of the Standard for
Aircraft Hangars , ANSI/NFPA
No. 409 in the USA, or the Canadian Natural Gas and Propane Installation Code ,
B149.1
A minimum clearance of 10 ft (3 m) above either the highest fuel storage compartment
or the highest engine enclosure of the highest aircraft, which may occupy the hangar.
The clearance to the bottom of the heater shall be measured from the upper surface of
either the fuel storage compartment or the engine enclosure; whichever is higher from
the floor.
A minimum clearance of 8 ft (2.4 m) must be maintained from the bottom of the heater
to the floor in other sections of the aircraft hangar, such as offices and shops, which
communicate with areas for servicing or storage. For proper mounting clearances, refer
to the clearances to combustibles in these installation instructions.
Heaters must be located where they are protected from damage to aircraft and other
objects, such as cranes and movable scaffolding.
Heaters must be located so as to be accessible for servicing and adjustment.