Easy Radiant Works ED-40U, Руководство по эксплуатации

Страница: 6 / 44

6
WARNING
THIS HEATER MUST BE INSTALLED AND SERVICED BY A TRAINED GAS
SERVICE TECHNICIAN ONLY. READ AND UNDERSTAND THESE INSTRUCTIONS
THOROUGHLY BEFORE ATTEMPTING TO INSTALL, OPERATE OR SERVICE THE
EASY RADIANT WORKS HEATER. FAILURE TO COMPLY WITH THESE
WARNINGS AND INSTRUCTIONS, AND THOSE ON THE HEATER COULD RESULT
IN PERSONAL INJURY, DEATH, FIRE, ASPHYXIATION, AND / OR PROPERTY
DAMAGE.
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPOURS AND
LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER GAS FIRED APPLIANCE
THIS APPLIANCE MAY HAVE SHARP EDGES AND CORNERS, WEAR
PROTECTIVE CLOTHING SUCH AS GLOVES AND PROTECTIVE EYE WEAR WHEN
SERVICING THIS OR ANY OTHER APPLIANCE.
APPLICATION
This gas fired radiant tube heater may be installed for heating of workshop / garages /
commercial / industrial / agricultural / non-residential type spaces. It is beyond the scope
of these instructions to consider all conditions that may be encountered. Installation
must conform with all local building codes or, in the absence of local codes, to the
National Fuel Gas Code, ANSI Z223.1/NFPA54 in the U.S.A. or the Natural Gas and
Propane Installation Code, CSA B149.1 in Canada. The latest edition Electrical Code
ANSI/NFPA N0 70 in the U.S.A. and PART 1 CSA C22.1 in Canada must also be
observed.
This appliance is approved for use in an attached garage only when required building
codes have been met for isolation/separation of the garage from the interior of the
residence, all required fire and air separations/barriers are in place, and all construction
is compliant with all required building and fire codes for such spaces
. In no case can
this appliance be installed inside of a residence or domicile including basements,
crawl spaces, storage areas, attics, living areas, or other any other attached areas
that are not isolated from the building as required by building code.
Installation of a gas fired tube heater must conform to all heating installation design
procedures including clearance to combustibles, connection to the gas and electrical
supplies, and ventilation.
This heater is not for installation in a Class 1 or Class 2 explosive environment. If
installation of this equipment is in question, consult with local authorities having
jurisdiction (Fire Marshall, labour department, insurance underwriter, or others).
Revisions or updates to codes and/or standards may require revision to equipment and
installation procedures. In case of discrepancy, the latest revisions of applicable codes,
standards, and installation manuals will supersede previous versions.