8
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
OPERATION
• Move the On-Off Switch located on
the underside of the Housing to the
“OFF” position.
• Plug the power cord into a 120VAC,
60HZ outlet.
• While holding the Eastwood Tungsten
Grinder securely, move the On-Off
Switch to the “On” position.
• Rotate the Speed Control Wheel located
at the top of the Housing to the 4th
position
(FIG 2)
. This is the ideal
speed setting for tungsten grinding.
• To begin grinding, allow several seconds for the motor to reach full speed then gently place the
tungsten into the proper width slot
(FIG 3)
.
• Slowly and steadily allow the tungsten to contact the face of the Diamond Grinding Wheel while
rolling the tungsten to create a sharpened tip. DO NOT force the tungsten but allow the abrasive
of the Diamond Grinding Wheel to do the work.
• When the grinding is complete, withdraw the tungsten and move the On-Off Switch to the
“OFF” position.
FIG. 2
FIG. 3
INJURY HAZARD!
Always hold the tungsten with open
fingers while grinding as it can
suddenly kick back causing hand
puncture wounds.
Use care not to cover motor cooling
slots with a gloved hand while in
operation to avoid overheating.
INJURY HAZARD!
DO NOT exert excess force on Tungsten while grinding as it can break and suddenly
eject sharp pieces at high velocity.
