To order parts and supplies: 800.343.9353 >> eastwood.com
7
• Depress the Armature Lock Button and
using a #1 Phillips screwdriver (not
included), remove the Diamond Grinding
Wheel Retaining Screw
(FIG 8)
.
• Remove and flip the existing Diamond
Grinding Wheel to reveal the fresh abra-
sive surface or replace with a new one.
• Re-install the Retaining Screw and
tighten in place.
• Back out all four of the Retaining Set-
Screws so that the ends are flush with
the I.D. of the Grinding Guide
(FIG 9)
.
• Slip the Grinding Guide back over the
Arbor Housing.
• Tighten all four of the Retaining Set-
Screws an equal amount so that the
Grinding Guide opening is fully con-
centric with the Retaining Screw at the
center of the Diamond Grinding Wheel
(FIG 10)
.
• The Eastwood Tungsten Grinder is now
ready for use.
FIG. 8
FIG. 8
FIG. 9
FIG. 9
FIG. 10
FIG. 10
