To order parts and supplies: 800.343.9353 >> eastwood.com
5
FIG. 1
FIG. 1
FIG. 2
FIG. 2
FIG. 3
FIG. 3
FEATURES
The Eastwood Elite TG2000 Cordless Tungsten
Grinder head features six machined slots:
- Two 1/16” slots; one angled at 10° and
one at 22.5° to direct the tungsten at
the preferred angle against the Diamond
Grinding Wheel
(FIG 1)
.
- Two 3/32” slots; one angled at 10° and
one at 22.5° to direct the tungsten at
the preferred angle against the Diamond
Grinding Wheel
(FIG 1)
.
- Two notches (1/16” & 3/32”) cut into
the top, outside edge of the Grinding
Head. These slots are designed to grip
the burned end of tungsten rods for
clean breakage
(FIG 1)
.
OPERATION
• Plug the Wall Charger into a properly
grounded, 120VAC, 60Hz outlet and
plug the USB-C charging cord end into
the charging port at the rear of the
Cordless Tungsten Grinder
(FIG 2)
.
• Allow the battery to charge to full capac-
ity as indicated by the three LED battery
charge indicators
(FIG 3)
being fully
illuminated. After charging, unplug the
wall charger and USB-C charge plug.
• While holding the Eastwood Elite Cord-
less Tungsten Grinder securely, move
the On-Off Switch
(FIG 3)
to the “On”
position.
Whenever switched on, the speed
setting will default to a middle
setting of 3. Setting 4 is gener-
ally optimal for tungsten grinding,
however this will vary upon user
preference.
✓
Armature
Lock Button
Power
Switch
Speed
Indicators
Battery
Charge
Indicators
Speed
Adjustment
Paddle
✓
✓
✓
✓
Low High
Low Full
On
On
Off
Off
Up
Up
Down
Down