To order parts and supplies: 800.343.9353 >> eastwood.com
5
FIRE OR EXPLOSION HAZARD!
•
DO NOT
use solvent based or flammable cleaning agents in this Ultrasonic
Cleaner. The unit is designed to operate with water-based cleaning agents
only. Exposure to solvents will destroy some components and could present
a fire hazard.
•
NEVER
allow the Ultrasonic Cleaner to operate while unattended. Resulting
overheating of the Transducer and other internal components can occur.
•
DO NOT
run the Ultrasonic Cleaner for longer than the maximum timer inter-
val. Overheating of the Transducer and other internal components can occur.
Allow a minimum 1-hour cooling period before re-using.
•
DO NOT
operate the unit without fluid in the tank. Minimum operating fluid
depth is: 2.75” [7cm].
•
DO NOT
attempt to move the Ultrasonic Cleaner while full. Always drain the
Ultrasonic Cleaner before moving.
•
DO NOT
place the Ultrasonic Cleaner on a soft surface, where the cooling
vents could be blocked. Use only on a hard, level, and stable surface.
SHOCK HAZARD!
• Always plug into an approved, grounded and GFI equipped 120 Volt AC,
60hz. Outlet.
• For indoor use only.
•
DO NOT
allow the cleaning fluid to splash on or contact any of the Ultrasonic
Cleaner controls or display.
•
DO NOT
touch the controls, housing, or power plug with wet hands, especially
when inserting or removing the plug.
•
DO NOT
attempt to move the Ultrasonic Cleaner while full. Always drain the
Ultrasonic Cleaner before moving.
• There are no user serviceable parts inside.
DO NOT
attempt to open or disassemble the Ultrasonic Cleaner unit.
• Always unplug the Ultrasonic Cleaner from the power source before filling
or emptying.
ADDITIONAL SAFETY INFORMATION
