To order parts and supplies: 800.343.9353 >> eastwood.com
3
6
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION used with the safety alert symbol, indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NOTICE is used to address practices not related to personal injury.
SAFETY INFORMATION
The following explanations are displayed in this manual, on the labeling, and on all other information
provided with this product:
READ INSTRUCTIONS
• Thoroughly read and understand these product instructions before using
this tool. Failure to follow all warnings can result in tool damage or
serious physical injury.
• Keep these product instructions for future reference.
RESPIRATORY HAZARD!
• Dust and fine particles are generated while cutting which can contain
hazardous or toxic substances. Breathing this dust can cause many serious
respiratory health conditions. Always use NIOSH approved respiratory
protection while using this Saw.
EYE INJURY HAZARD!
• Rapidly rotating surfaces can eject metal particles, dirt and oils at high
velocity. Always wear ANSI approved eye protection when operating this tool.
HEARING DAMAGE HAZARD!
• The Eastwood 3” Inline Cut-Off Tool emits high sound levels while operating.
Use ANSI approved ear protection when operating this tool.
ADJUST GUARD
• Using the included 3mm Hex Key, loosen the Socket
Head Clamping Screw slightly, rotate the Guard to
the desired position then re-tighten screw.
OPERATION
• Adjust the Speed Control Lever located on the left
side of the handgrip section of the main tool body
(Fig 3)
.
• Connect air supply, hold tool
securely, flip Safety Lever
under Paddle and depress
Paddle to begin rotating action
(Fig 3)
.
MAINTENANCE
• Add several drops of air tool oil
before each use directly into
the air inlet.
• If tool is to be unused for an
extended period, add 10 drops of air tool oil directly to the air inlet, rotate the tool motor by
hand several times to distribute the oil throughout the motor and gearbox then store the tool,
handle up.
• With the air supply disconnected, periodically check that the Socket Head Wheel Retaining
Screw is tight.
FIG. 2
INJURY HAZARD!
• DO NOT
operate Cut Off Tool without Guard in place!
INJURY HAZARD!
• Disconnect air supply from the tool to prevent accidental starting and potential injury while
making adjustments to the Guard
(Fig 2)
.
FIG. 3
✓
Rotate To Adjust Speed
Press Paddle
Rotate
Safety Lever
